P0174 BMW Fault Code
Check P0174 OBD Fault Code ReasonOutput Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.
P0174 Code Symptoms :
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the P0174 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
Diagnosis And Repairing P0174
Parts or components should not be replaced with reference to only a P0174 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.
How to fix P0174 code ?
- EVAP system hose leaking
- Faulty oil control valve (OCV)
- Damaged camshaft position (CMP) sensor
- Internal electrical failures in actuator motors/solenoids.
A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the BMW DVOM on the voltage setting. You will want to test the fuses with circuits loaded.
Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.
